We’re Not Just Forming Parts, We’re Forming Solutions!

Rebuild Information

Available Rebuild Formats…

- Former-Only Roll-Fed Thermoformers

- Former & In-Line Steel-Rule Trim-Station Roll-Fed Thermoformers

- Contact-Heat Former-Only Roll-Fed Thermoformers

- Form & Trim-In-Place Roll-Fed Thermoformers

Standard Machine Rebuild Specifications:

  • Rebuild/Repair Un-Wind & In-Feed Systems
  • Rebuild/Repair Upper & Lower Oven-Heating Banks - Repair/Replace Exiting Electric Heating Elements
  • Rebuild/Repair Upper & Lower Form-Station &/or Trim-Station Platens

              - Rebuild Toggles/Actuator-Arms & Platen-Guides

                 - Hydraulic, Pneumatic or Electric Platen Drive System

  • Rebuild/Repair Pin-Chain Sheet-Transfer System
  • Install New Electric-Index System
  • Rebuild Complete Machine Pneumatics
  • Rebuild Complete Hydraulics (as applicable)
  • Re-Wire Complete Machine Electrical
  • New PLC Machine Controls
  • New & Re-Conditioned Guards
  • Clean & New Paint

Available Machine Rebuild Specifications/Options:

  • New Powered Un-Wind &/or In-Feed Systems
  • Form-Station &/or Trim-Station Platens

                - Install New Hydraulic or Pneumatic Actuation Cylinders

                - New Servo-Electric Toggles Platen-Drive Systems

  • Oven-Heating System

                - New Ceramic Heating Elements Oven-Heating System

                - New Electric Panel Heating Elements Oven-Heating System

                - New Quartz Tube Heating Elements Oven-Heating System

  • Oven-Heating Banks Opening Systems…

                - Clam-Shell Conversion

                - Roll-Out Converesion

  • New Pin-Chain Slide-Rails Sheet

                -Transfer System

  • Controls - Optional PC Based Controls
  • Exit-End Plastic-Slitter
  • In-Feed Sheet-Edge Pre-heaters

Rebuilt Equipment

See machines